Motor idea ...
03-11-2006, 11:21 PM
#2
TECH Addict
It'll be a 370cid 6.0.....the 5.3 crank is the same as a 6.0 crank
Now the 4.8 crank is another story....4.030" bore x 3.286" stroke = 333cid 8000rpm toy, Run a T-ReX or G5X4 cam and spin that puppy !!!
Now the 4.8 crank is another story....4.030" bore x 3.286" stroke = 333cid 8000rpm toy, Run a T-ReX or G5X4 cam and spin that puppy !!!
Last edited by Yelo; 03-11-2006 at 11:41 PM.
03-11-2006, 11:40 PM
#3
TECH Veteran
iTrader: (6)
Join Date: Nov 2003
Location: Tallahassee, FL
Posts: 4,397
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Yelo
Now the 4.8 crank is another story....4.030" bore x 3.286" stroke = 333cid 8000rpm toy, Run a T-Race, T-ReX or G5X4 cam and spin that puppy !!!
03-12-2006, 12:18 AM
#5
TECH Addict
I'm thinking the FAST intake, a custom Crane 242/248 .610/.610 112 cam and Stage III Patriot Heads, According to Dynosim that combo will net you 546hp @ 7000rpm and 498 ft/lbs @ 5000rpms....not too bad for a 333cid motor
Thats close to what I was going to switch to in my 418Trending Topics
03-12-2006, 09:35 AM
#8
TECH Senior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2003
Location: Armpit of East TX
Posts: 9,342
Likes: 0
Received 0 Likes
on
0 Posts
I dunno that I would be able to tune that cam in for that little of a motor. The 233/239 was hard enough and still cannot get just right.
I'll have to think about this though.
I'll have to think about this though.
03-12-2006, 09:35 AM
#9
TECH Addict
iTrader: (2)
Join Date: Feb 2004
Location: Tampa, Fl
Posts: 2,784
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Yelo
It'll be a 370cid 6.0.....the 5.3 crank is the same as a 6.0 crank
Now the 4.8 crank is another story....4.030" bore x 3.286" stroke = 333cid 8000rpm toy, Run a T-ReX or G5X4 cam and spin that puppy !!!
Now the 4.8 crank is another story....4.030" bore x 3.286" stroke = 333cid 8000rpm toy, Run a T-ReX or G5X4 cam and spin that puppy !!!
