where are you guys moutning your bottles?? (i know this sounds like a stupid question) im thinking about running nitrous in my truck after i get the engine in and im in debate on where to mount the bottle. suggestions

 

right behind the driver's seat

 

I had mine mounted between the front seats and had no console, now I have a console so when I put nitrous back on my truck I'm going to either mount the bottle behind the drivers seat or in the bed (if I go ahead and get a bed cover) my main issue is that I have a 15# bottle.

 

behind the pass seat.
i have dual 10" speaker box that takes up space behind my drivers seat and center console. i can reach over and open the valve from my drivers seat when i want to.

 

 

I made a plate to mount it behind the passengers seat. Its sitting at the proper 45* angle, is close enough to easily reach from the drivers seat, and is mostly hidden

 

hmmm...thanks guys. was thinking about behind the seat but wasnt positive if there would be enough room. and then i was thinking about the bed and putting my bed cover back on but the only problem is my bed cover is a soft cover and just dont trust people ya know?

 

hey man do you have any problems with the bottle like that? I have my bottle mounted in the bed and i want to installed like that.

 

I have mine mounted inside center console cause my speakerbox takes all the space behind the seats. Pics on a thread under Nitrous Oxide Section.

 

there shouldn't be any problems.
all you have to do is make sure the end of the siphon tube is pointing to the rear of the truck.