Beat a C4 last night
#1
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Feb 2002
Location: Texas
Posts: 910
Likes: 0
Received 0 Likes
on
0 Posts
Beat a C4 last night
It was really funny. The guy did a dragster type burnout, and it seemed as if I was going to get my *** handed to me. The guy red lights a .480 to my .521. He is burning rubber as I hook with no tire spin , I run a 15.18 at 89 mph and he runs a 15.39 at 102. If he knew how to drive he could easily go 12.80 to 13.0(with slicks). Fartruc goes 14.49 with wheel spin, with the new LS6 block.
#4
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Feb 2002
Location: Texas
Posts: 910
Likes: 0
Received 0 Likes
on
0 Posts
Re: Beat a C4 last night
</font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">Originally posted by CashDudeHomie:
<strong>Tell Farmtruk to put a posi in already!!!!</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">He is looking to rebuild his rearend pretty soon, or find one at a junkyard. Either way he will do something in the near future.
<strong>Tell Farmtruk to put a posi in already!!!!</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">He is looking to rebuild his rearend pretty soon, or find one at a junkyard. Either way he will do something in the near future.
#5
Performance Trucks Sponsor
iTrader: (5)
Join Date: Jul 2002
Location: san antonio, tx
Posts: 1,439
Likes: 0
Received 0 Likes
on
0 Posts
Re: Beat a C4 last night
ya, it was fun out there like always,
i'm trying to save up for a new posi and gears, i'm not going to do anything to the engine until i get traction. my last run was something like a 17.x , that was after i gained control of tire spin. at least it looked neat,
i figure i'll go with an eaton posi and 4.10 gears, with about 29inch slicks. i can't wait to nail it off the line instead of easing into it,
work in progress has a crazy launch and always has a good reaction time, like a drag racer <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
i'm trying to save up for a new posi and gears, i'm not going to do anything to the engine until i get traction. my last run was something like a 17.x , that was after i gained control of tire spin. at least it looked neat,
i figure i'll go with an eaton posi and 4.10 gears, with about 29inch slicks. i can't wait to nail it off the line instead of easing into it,
work in progress has a crazy launch and always has a good reaction time, like a drag racer <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Thread
Thread Starter
Forum
Replies
Last Post
legerwn
Tuning, Diagnostics, Electronics, and Wiring
56
11-15-2015 10:21 PM