https://ls1tech.com/forums/dynamomet...bolt-dyno.html

check out the cam. Look at that torque curve

 

Got my attention, I bet that cam would be a beast in my LQ9

 

You're too much of a wuss to go bigger than the stangbanger!

 

I got my Ed Curtis cam installed this last weekend, and I really like the down low TQ it added... It also pulls even higher than my previous 222/224 cam... I am hoping to get to the track to do some tuning next week, if i figure out what my TC problem is...

 

what were the full specs on yours again blackGMC?

I'd like to try out an ed curtis cam, but I just saw a tr224 go brand new on ebay for $190, so I'll likely end up going with the cheapest route.

 

all that torque has alot to do with the heads

 

specs are in my sig

true...

 

You must have JUST updated that

 

Hirdle has very similar heads, he's also running thru a manual trans.

 

Yea, I guess you've got my number, the stangbanger is what I want. If my truck ever becomes a weekend warrior though, watch out! 3800 verter, cam in the 226+ range, steep gearing....I've got it all planned out for someday