so i have a 99 ecsb 4x4 with 5.56s and 35s. im building the 6.0 i have for the car now, so the 5.7 is goin in the truck. the truck has an ls6 cam and that will be getting swapped to the 5.7. im going to do some porting on the heads and new lifters cause the car bent a couple pushrods. i was thinking about millingh the heads but it already has 10:1 and i dont know how much i can go and run 93. any suggestions would be helpful.
im doin this as cheap as i can thats why im not gettin a diffrent cam.
its gettin lts and an x-pipe too.