Larry, bone stock, even has the factory paper air filter. <img src="gr_stretch.gif" border="0"> Wow, that pulley on your truck gave a nice torque increase!

Don't forget, the track I run is at ~1900' elevation, so I'm sure there are a few extra tenths there.

I'll try to scan the sheet & post it later. I wish it showed figures under 3600 RPM, but that's where it shifts into 3rd, so that's when he pressed the button. The torque stays above 290 till 4400rpm and slowly drops to ~220 @ the 5600rpm cutoff. Horsepower peaked at 4800rpm.

 

I'm jealous. You guys are killing my #s.
Ryan

 

Sorry Neil, I noticed in your sig that you are the slowest truck on here. I ran a 16.45 on a g-tech, so I'm going to have to take your title <img src="gr_grin.gif" border="0">

 

Damn Nick, I worked really hard to earn that title. <img src="gr_images/icons/wink.gif" border="0"> Defend it with pride! <img src="gr_grin.gif" border="0">

Ryan, I figured we would have very similar numbers...was your truck dynoed in 2nd or 3rd gear?

New sig!

 

Neil,

Those were peak numbers off my chart. Throughout the range I did not gain that much. But there is something to be said about the underdrive!

I am sure Brooke is right about whipping me. If you get that 60' down and with same density altitude you will surely spank me. And certainly with a few free mods.

 

[quote]Originally posted by Neil 6.0:
<strong>Damn Nick, I worked really hard to earn that title. <img src="gr_images/icons/wink.gif" border="0"> Defend it with pride! <img src="gr_grin.gif" border="0">

Ryan, I figured we would have very similar numbers...was your truck dynoed in 2nd or 3rd gear?

New sig!</strong><hr></blockquote>


I like the new sig, don't get any slower or I'll have to take off some mods.
<img src="gr_stretch.gif" border="0">

 

Neil, you gonna line up against Jason's truck at the track? I'll disconnect the bottle <img src="gr_stretch.gif" border="0"> then it could be 6.0L vs 6.0L N/A <img src="graemlins/gr_cheers.gif" border="0" alt="[cheers]" />

 

Neil, I had to dyno in 2nd gear because of the speed governor. <img src="gr_sad.gif" border="0">
Ryan

 

The dyno sheet should be @ this link...

http://community.webshots.com/album/27319632ZZlxVJgKQV

<img src="graemlins/gr_punch.gif" border="0" alt="[fight]" />

 

I made it there too late to see the HOSS 6.0L make some dyno runs. <img src="gr_sad.gif" border="0"> It was good to see again Neil! I love that grey on your truck. My truck is the same color but with pewter trim around the bottom. I was very impressed w/ the #'s you put out for not having any HP mods! Y'all should come to the Motorplex on Saturday. high of 54 and low of 27 <img src="gr_eek2.gif" border="0">