JDScherz

I just installed a vette servo today, and after a little mishap..snap ring wasn't all the way in, but luckly the heat shield kept all parts from scattering on the road. I returned after a very short smokey drive back to shop and replaced the cover and made sure the snap ring was in this time. On the way home I was pleased with the 1-2 and 2-3 shifts, but NO 4th gear??? Just wondering if anyone else has any suggestions??
I did just have a Black Bear tune prior to this install, but can't see that affecting anything??

TX Tahoe Z71

iTrader: (28)

You leave a washer out?

JDScherz

Well I believe I only saw one washer, between spring and clip on stem is this correct?

built408

iTrader: (10)

Yes, that's correct.

Were any of the sealing rings damaged when they came out?

JDScherz

Thats tomorrows adventure...do it all over again. Maybe 4th gear servo ring damaged??

Tootall

iTrader: (79)

there's a small spring that is between the case and the 2nd gear servo. It goes around the pin . . . did you put that back in ?