shimming converters

Reply Subscribe

Thread Tools

Search this Thread

Sep 14, 2006 | 03:34 PM

#11

DrX

TECH Addict

iTrader: (7)

Joined: Jun 2005

Posts: 2,703

Likes: 6

From: Canada

No problems with my PI 2600 since I installed it last winter. There was a lot of discussion about the shimming. According to PI's instructions at the time shims were required. We did some converter measurements and Chuck from FLT spoke with PI about this. It was decided that the shims were not required.

Sep 14, 2006 | 03:43 PM

#12

silver-mod-o

Thread Starter

Hunt&Fisherator

iTrader: (15)

Joined: Nov 2005

Posts: 14,314

Likes: 17

From: SETx

well then its going in without shims... Just needed some reassurance...

Sep 14, 2006 | 04:17 PM

#13

1slow01Z71

Tin Foil Hat Wearin' Fool

iTrader: (36)

Joined: Oct 2004

Posts: 23,204

Likes: 4

From: Austin, TX

I tolded you focker

Good luck Ben I sure as hell hope this one stays together for you. I bet you are tired of wrking on that damn thing.

Sep 14, 2006 | 05:11 PM

#14

ZR1 DREAMING

TECH Senior Member

iTrader: (28)

Joined: Aug 2005

Posts: 8,277

Likes: 1

From: Ham Lake, MN

Quote:

Originally Posted by 1slow01Z71

I tolded you focker

Good luck Ben I sure as hell hope this one stays together for you. I bet you are tired of wrking on that damn thing.

lol... tell me about it, probably as tired as you are.

Sep 15, 2006 | 07:34 AM

#15

silver-mod-o

Thread Starter

Hunt&Fisherator

iTrader: (15)

Joined: Nov 2005

Posts: 14,314

Likes: 17

From: SETx

Quote:

Originally Posted by 1slow01Z71

I tolded you focker

Good luck Ben I sure as hell hope this one stays together for you. I bet you are tired of wrking on that damn thing.

now I have one of the converter pads that has gaulded up threads... I'm going to run a tap in there in a little bit to see if I can clean it up... I am damn sure tired of working on ith though... I wanna drive it some... dammit.