my stock shocks in the rear are too soft and bouncy since it's been droped 4". i've been looking into the QA1's b/c of the adjustability. i can't seem to find any application for my truck. my question is, which shock/part # do i need for the rear and what hardware is all needed to do the install? again, the rear is droped 4" with the shackle/hanger kit. thanks in advance guys. later... lance

 

Try a PM to creederado, he has them on in his stepside.

 

I'd like to know about these QA1's too. any info you find would be aweome. I have really been following you n/a 5.3 guys and you are doing an excellent job of keeping the bar LOW.

 

thanks tdrumm. i remember seeing a write up about it awhile back. i think they had to mess with the spacing/washers or something...

 

If you get the Pn for it post up or PM me blue I need to put a set on my truck along with cal tracs to get my POS to hook up in 4wd.

 

as soon as do some more reading and find out more info i'll let you know. but our trucks will probably have different part #'s b/c my truck is lowered.

 

My truck will be lowered 4 inches in the rear. So I will sit 2 inches higher than you due to ahve lift blocks stock in the rear of mine.

 

you need to take out those blocks cody... it will look way nicer

 

Here is a post by F8L Z71 that should give you an idea of what he used on his truck with a 2/4 Hotchkis drop.

 

thank you mort. i've been looking at his and creeds. i'm leaning towards creeds b/c f8l had to change the top t-mount to an eyelid mount. still reading upon it though.