4L80E swap guys in here, do you have drive shaft length?
#11
TECH Senior Member
iTrader: (26)
My 98 Burb needed to have the rear driveshaft shortened by 42mm.
I measured from the face of the bellhousing (where it bolts to the motor) to the mounting face of the NP243 transfer case (so....including the transmission to transfer case adaptors...which are different widths)and the difference between the two was 42mm.
This was perfect for mine.
Front drive shaft on the OBS's has a fair amount of 'telescopic' movement in it and didn't need altering.
I measured from the face of the bellhousing (where it bolts to the motor) to the mounting face of the NP243 transfer case (so....including the transmission to transfer case adaptors...which are different widths)and the difference between the two was 42mm.
This was perfect for mine.
Front drive shaft on the OBS's has a fair amount of 'telescopic' movement in it and didn't need altering.
Thread
Thread Starter
Forum
Replies
Last Post
lxcoupe
FORCED INDUCTION
8
07-21-2015 02:12 AM