...on your 5.0 project until you read this add...
Ford 5.0 roller cam engine for sale
block boiled/mag'd/decked
punched +.030, Keith Black 10.5:1 pistons
All new internals, Pro assembled
Receipts for $2962.22
Comes with bell/Flywheel/fork/engine stand
52cc heads ported and polished
Gasket matched intake, go carb or EFI
Make serious offer... Chris
203-232-8298
Deliver within reason or crate ship at actual cost.

 

 

Perhaps you should post this on StangNet.com...... You might have better luck....

 

Thanks Black, I'll try that too.
I like your metal work on the Stang, very clean.
I was doing this engine for an 84 GT350 but it was a numbers matching car and I couldn't bring myself to cutting it up to drag. I sold it to someone who started a full resto on it. I then set my sites on dropping the 5.0 into my Miata, but now that there is a kit for the LS-1...well I'd rather slip that in. Weighs less, I have one and the 6 speed, just and easier project overall.
Thanks again... Chris

 

Thanks!!