thunder550

iTrader: (70)

Holy stump-pulling torque!!!

leftcoast32

iTrader: (4)

I want one on the TBSS next!!!!

DrX

iTrader: (7)

I think that performance map may have to be extrapolated a little to cover that!

supersub

iTrader: (25)

The line starts here! brotha LOL!

leftcoast32

iTrader: (4)

That will be a monster on the right engine!!!!!

trever1t

iTrader: (14)

hotdamn!

03sierraslt

iTrader: (22)

Cool, now put it in a vehicle. Question is- On a truck setup were its not a rear drive is the possibility still going to be there to spin this thing fast enough to make a decent amount of boost on a big CI motor? The only setups that are putting out boost #'s over like 9-10 on anything bigger then a 6.0 are front inlet and are being overspun via the rear drive as well.

zippy

I believe that the 2300 will be able to make 8-10psi or so on a 7.0L without having to be overdriven. I'm only basing this info on the map of it that was shown and other minor information. This blower looks to be quite a bit bigger and better than the MP122.

NORCAL TBSS

iTrader: (3)

i thoguht the tvs you wouldnt be able to hear the supercharger im glad you can!!!!!!!!!!

BlownChevy

iTrader: (20)

at the lower boost levels (10 psi and below) the blower is very quiet.