one more item showed up today..................hopefully these are the right size. I went off of CHarris's thread a while back. He said 5/8" long spacers where needed for the 60lb Mototrons, and for $8 shipped for 10 I figured I'd give them a shot:



I'll assemble the rails and injectors later today and report back

 

are you installing just the blower so we can see a true gain from the 122 swap?

 

how close are we to ignition?

 

I'd like to get it installed this weekend, but that may not be an option, I'm missing a few small parts and pouring a slab of concrete in the backyard tomorrow. By next weekend for sure

 

ideally yes

 

Looks nicer than my slightly crooked hacksaw cuts... lol Those should serve you well and are the right size to get it done.

 

Anyone we know?!?!?! LOL

 

so youre the guy that outbid me.....

 

you are always getting the shaft

 

not the parts I was hoping would show up today but it does put me one step closer to completion.....I figure these will give a nice measure of insurance, especially after what happened to CHarris when his rod let go on decel, I figure this is the least I can do.