Boost Reading with a 3.2" Pulley
08-13-2008, 02:51 PM
#13
FormerVendor
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Posts: 1,940
Likes: 0
Received 0 Likes
on
0 Posts
I have never seen pressure like that in the TBSS even brand new. We kept the stock pump and spring when the bottom end was forged and the pressure has never changed.
08-14-2008, 08:43 PM
#17
Do you ever drive that thing? Your engine bay and undercarriage are way too clean. 
How do you have your PCV system set up? I see what looks like two pass side valve covers with breathers on the fill tubes. Is it just vented to atmosphere or do you have something else pulling vacuum from the crank case? I hope to see close to 15# on mine with the pulley and throttle body swap I did last weekend. When I pulled the TB I noticed oil on the TB and about a table spoon of oil pooled in the j-tube.
How do you have your PCV system set up? I see what looks like two pass side valve covers with breathers on the fill tubes. Is it just vented to atmosphere or do you have something else pulling vacuum from the crank case? I hope to see close to 15# on mine with the pulley and throttle body swap I did last weekend. When I pulled the TB I noticed oil on the TB and about a table spoon of oil pooled in the j-tube.
