2bar Map not reading right

Reply Subscribe

Thread Tools

Search this Thread

Jul 25, 2010 | 06:45 PM

#11

DrX

TECH Addict

iTrader: (7)

Joined: Jun 2005

Posts: 2,703

Likes: 6

From: Canada

Quote:

Originally Posted by joeyc125

That helps, in HPT, i have a scalar that is recommended to be 200, and an offset recommended to be 10.33. That is what I started with, so you are saying I should adjust the scalar from 200?

Yes. Log the reading off a vehicle equipped with a 1 bar sensor, log your 2-bar at the same location and time, and adjust from 200 as necessary so that it it reads the same. See where that gets you.

Jul 25, 2010 | 07:26 PM

#12

joeyc125

Thread Starter

11 Second Truck Club

iTrader: (7)

Joined: Nov 2007

Posts: 800

Likes: 0

From: Cedar, MN

Will do, thanks.

Jul 26, 2010 | 03:37 AM

#13

Blown06

8 Second Truck Club

iTrader: (32)

Joined: Apr 2006

Posts: 5,662

Likes: 47

I think you have to delete the MAF pid in the scanner table as well. I could be wrong though, its been a while since I've looked at the SD set up how to in the Help section.

Jul 26, 2010 | 02:51 PM

#14

TURBHOE

12 Second Truck Club

iTrader: (4)

Joined: Nov 2004

Posts: 6,318

Likes: 2

From: Jacksonville FL.

In the scanner there is a two bar lid and then there is a gm two bar pid. The gm two bar is scaled for just that, a gm two bar sensor. I'll have a look at mine in a few and post numbers up.

Jul 26, 2010 | 03:19 PM

#15

joeyc125

Thread Starter

11 Second Truck Club

iTrader: (7)

Joined: Nov 2007

Posts: 800

Likes: 0

From: Cedar, MN

I am not seeing the GM 2bar, just the manifold air pressure 2bar

Jul 27, 2010 | 07:25 PM

#16

joeyc125

Thread Starter

11 Second Truck Club

iTrader: (7)

Joined: Nov 2007

Posts: 800

Likes: 0

From: Cedar, MN

Quote:

Originally Posted by TURBHOE

In the scanner there is a two bar lid and then there is a gm two bar pid. The gm two bar is scaled for just that, a gm two bar sensor. I'll have a look at mine in a few and post numbers up.

You ever look at those numbers?