Went away to cabin up near Deep Creek Lake, MD...truck broke
nice....
Feb 2, 2009 | 06:57 PM
#13
Joined: Apr 2004
Posts: 16,820
Likes: 2
From: In a van DOWN BY THE RIVER
Broken arm fix it with this, broken neck, no sweat get this to fix it quick .. HAHAHAHAHAHA
Feb 2, 2009 | 06:59 PM
#14
Adkoonerstrator
iTrader: (4)
Joined: Nov 2001
Posts: 21,436
Likes: 3
From: Deep in the seedy underworld of Koonerville
Feb 2, 2009 | 07:08 PM
#16
Registered User
Joined: Feb 2009
Posts: 8
Likes: 0
From: Portland TN
ROTFLMAO How funny,
yeah see what happens when you go putting on all that aftermarket stuff ???? I see you replaced it with another similar pulley just like the one that let you down.
You do know about the definition of insanity right????
doing the same things over and over again with the same variables performing everything in the same manner expecting a different out come each and every time... lol
yeah see what happens when you go putting on all that aftermarket stuff ???? I see you replaced it with another similar pulley just like the one that let you down.
You do know about the definition of insanity right????
doing the same things over and over again with the same variables performing everything in the same manner expecting a different out come each and every time... lol
Feb 2, 2009 | 07:20 PM
#17
Thread Starter
Joined: Nov 2004
Posts: 27,563
Likes: 3
From: Maryland
ROTFLMAO How funny,
yeah see what happens when you go putting on all that aftermarket stuff ???? I see you replaced it with another similar pulley just like the one that let you down.
You do know about the definition of insanity right????
doing the same things over and over again with the same variables performing everything in the same manner expecting a different out come each and every time... lol
yeah see what happens when you go putting on all that aftermarket stuff ???? I see you replaced it with another similar pulley just like the one that let you down.
You do know about the definition of insanity right????
doing the same things over and over again with the same variables performing everything in the same manner expecting a different out come each and every time... lol
Are you talking to me or blownchevy? I mentioned in an above post I plan to go to stockerS (as in plural). LOL My setup runs TWO metco pullies, I had 2 metcos, now only have one cuz the other took a ****. Then had to buy a smaller belt because the setup was missing one of the pullies, therefore leaving just one pulley on there. Which just in case you only read the last lines of paragraphs (i am VERY guilty of that myself) means I did not reinstall a metco pulley expecting different results.
Feb 2, 2009 | 07:28 PM
#19
Hanock ain't bad, Old Town, now that's a place to see!!! And if that doesn't do ya', try Weverton, MD- near Harper's Ferry, WV...
Yeah, westen MD chicks are HOTT!~!