So finally after the new set up i had the ***** to put the factory 4l60 on the track behind my new setup...... Keep in mind i am running a 28x11.50 mt et street II. I was at 17psi tire pressure. I made a total of three passes trying to get it to leave and this is what i came up with:
Keep in mind this is 500 ft so add about .6 tenths for a full 1/8.

My fastest pass spinning past 330 was a 7.021......put that in the calculator with the mph i ran @ 80mph and that will be about a 7.7 1/8 and net about a 12.9 on a n/a car. We measured the "60ft" and its actually 62 ft so my 2.0 wasnt that bad just when it shifts to second i unload and break loose.

I hope with boost it is making a bigger mph and net me a better time in the 1/4!
But i am satisfied if i truly see some 12's on a real 1/4 track soon!

 

What was your ET and MPH at the 330 mark?

 

no mph but it was a 5.42 @ 330 and still spinning on my 7.0 pass.
im ordering cal tracs and shocks prolly next week and then moving the battery too!

 

that 330 is closer to an 8.3-8.4 in the 1/8. good times though. don't they have any normal track where your from?? 500ft LMAO

 

I would agree i have a time slip from last sunday and I was 5.499 @ 61.68 and i ended up running a 8.5 @ 80.08mph...

 

Pretty good times

 

my 8.3 time slip had a 330 of 5.358

 

Good times man. Congrats!!!

 

The 60ft is actually 62ft? I would throw out all the information you have as far as numbers go for that track. How do you know it is even 500ft?

 

The 60' is actually 60', and for 1/8 time add 1.2 sec.