Truck should do good. Txsiverado and ap2002 had similar mods and ran those numbers.

 

For sure. Perfect time to slap in the new one .

I thought I read the new tranny was already in (read it wrong apparently).

 

i dont see a problem with your goal. worst case you need to go back to the 78mm bc the 90mm swap isnt right for your combo.


i wanna race

 

 

Well I just measure my new headers, and they Aint 1 3/4 primaries & will have too clean up the welds too get better flow. Skeet you were right again! I hope the 3" collectors help over the 2.5" collectors.

 

im going with a 325/50/15 bfg drag radial. I was running nitto 275/40/17's drag radials. these ones will be wider and taller with more side wall so we will see. I picked them up brand new for $150.00 for both so i figured id give them a shot.

 

Thats a good deal
Try air pressure around 20-25psi.. i know every tire & truck is different,but i dont get anything below 20psi. ive tried 13-15psi & all it did was spin.

 

if you didnt buy the bfs yet go with the mt et street radial. my cousin went from mt's to bfs cause of a good deal and regrets it.

 

what converter are you running? that might be the limiting factor right there.

 

278mm 3200 Circle D. I may go with a little verter later, but as of right now in sticking with the 3200.