A lot of this is stuff I had left over from my build. Thought someone here might make use of some of it:

SOLD Brand New Bosch 044 fuel pump. M18 X 1.5 female inlet and M12 X 1.5 female outlet. Never had fuel through it. $175 Shipped SOLD


2000 C5 Vette 78mm throttle body **NO TPS, I removed it after this pic was taken to use on my truck**. Works great, just not what I needed. $50 Shipped


Brand New Generic Heat Exchanger. $90 shipped



Brand New Magnuson Truck Heat Exchanger $75 shipped


FAST Injector Harness Adapters - EV1 to EV6 170603-8 $65 Shipped


Truck 87mm Throttle Body. Not sure what year/Model uses this.
$75 Shipped


Alkycontrol Methanol Kit. You guys all know that quality of these kits. It has a progressive controller with a 2 bar map wired into to it. It’s a pretty sweet setup. I never got to install it and it looks like I won’t need it. It comes with a reservoir that I think fits the NNBS trucks. Lots of wiring harnesses, a couple of LED’s, and relays. I don’t remember what I paid for this but I’m sure it was more than... $425 Shipped






TVS Pulley 6-rib 3.6” New $65 shipped**TVS Pulley 8-rib 3.2” New $80 shipped

 

Buy my stuff. It's cooler than that other stuff you were just looking at.

 

I am guessing that you purchased the Alky Control used since it does not look brand new and you stated you never got to use it. Do you know how old it is? It appears to be in good shape.

 

He bought that kit from me. It is all in great shape! I used it for one summer so I'm guessing it's about 2 years old this next summer.

 

Thanks for the info. Almost 2 years old sounds logical. Like I said, it looks in good condition. Did you have a custom set-up on your truck? There looks to be alot of extra wiring and stuff. It looks like a complex kit.

 

I had a custom fuel cell for the meth and then switch it over to the washer reservoir. That is the way all those kits come. I bought two new led kits to sell it because I mounted my leds in the pillar pod so i just left them there. It's not very complicated to wire up. He has the instructions with it and Julio at Alky Control will help too if needed.

 

Thanks Scooter K, I was at work and couldn't respond. I think the instructions have been "mislpaced" but I can look a little harder. It's ready to go!

 

Bump...I take offers.

 

Interrested in alky pm me whith ur best price

 

Price dropped on the Alky Kit $425 Shipped