So I plan on changing the stepper motors on my gauge cluster because it is tons cheaper than sending it off. Anyway all the write ups I see show the needles already zeroed out so they can put tape down and mark where the needle was at. On mine the needles have been long dead and never zero out. Tranny temp gauge stays pegged and tach will be real jumpy but never goes below 2k. How would I go about knowing where to put them back to where they are supposed to start?

 

Silverado777 would be a good guy to ask. (Sorry if i f'ed up his username)

 

I'll look him up. Thanks

 

Anyone in local Dallas area can pm me for help with clusters, with all the members on PT we should have to send anything off to be fixed. let's help fellow truck fanatics out!