Is this possible using LS components? I know you can run LS coils on one, just wondering if anyone has setup a 4150 throttle body on one. I know with an LS I can find step by step info on doing it but not on a Gen 1. A 350 is easier to grab than a 6.0L and if I can just use the electronics off of one I could use a 4.8L parts truck which would be much cheaper. Still up in the air weighing in my options. I already have the accessory drive for a Gen 1 and my truck is pretty much set up for it already. I could just keep TBI but its a wiring hassle to run two computers and an EDL. And then that's $500ish plus with any serious power I'd need a 454 throttle body. Seems like a lot of money and can't tune the transmission without messing with chips.