85 s10 2wd blazer roller was a small block truck cheap
#1
Thread Starter
Joined: Apr 2011
Posts: 620
Likes: 5
From: Trenton,nj
I have too much stuff going on to give this truck any attention will let it sit if it doesn't sell .... first off its not real good looking but it does have drop spindles and springs up front and rear drop leafs all new ball joints were installed at that time also but has been sitting for years rolling on new body steelies with tires that hold air . Previous owner tried filling body line with filler cleaned all out except passenger door also some filler between door and wheel wells but wheel wells look fine extra set of quarter glass with privacy tint goes with it taillights etc .... front clip basically laid on it trying to inspire me to work on it would make a fun little ls build just don't see many of these anymore would sell cheap to someone who will do something with it starting at $500 make offer will accept trades let me know what you think trying to post pictures
Last edited by mitchellmade; Oct 22, 2014 at 08:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
07NBSChevy
GM Engine & Exhaust Performance
20
Jul 8, 2015 07:27 PM
GreyChevy
Tuning, Diagnostics, Electronics, and Wiring
1
Jul 7, 2015 08:57 PM






