Need help on pipe saddle cutting
#1
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Nov 2008
Location: Sweeny tx, Somewhere in Afghanistan
Posts: 67
Received 0 Likes
on
0 Posts
Need help on pipe saddle cutting
I have a hands on test coming up and wanting to know a little bit of information, since I don't know much about it....I want to know the points to mark on the pipe, how many points to mark, and it's going to be a 6 on 6 saddle and a 6 on 8 concentric 90 degree T. the formula I have is circumference= radius X2 X 3.14. It's just a new field I'm going in so . I have built pipe fences before and made saddles using templates ( not allowed to use on test ) . So I want to know how to measure out on the pipe. Just need to make sure...
Thanks people, don't beat me up to bad on this...
Thanks people, don't beat me up to bad on this...
Thread
Thread Starter
Forum
Replies
Last Post
jscherbs
GM Parts Classifieds
3
09-30-2015 07:54 AM
lt1z350
GM Parts Classifieds
5
09-28-2015 12:20 PM
Velocity1
GMT 800 & Older GM General Discussion
6
09-22-2015 01:32 PM