DFW Dyno Day Saginaw Texas October 16
10-19-2010, 02:05 PM
#52
TECH Addict
iTrader: (21)
Join Date: Apr 2008
Location: Fort Worth, Texas
Posts: 2,625
Likes: 0
Received 0 Likes
on
0 Posts
not bad at all man! on a 60ish shot. did you do any n/a pulls? swap it out to a plate and see the tq numbers jump into the 400's. mine put 407hp/534tq with a rich 100 shot and the tr224 only+ boltons. back in april. I hope for ~475-500 hp and 550+tq with the new stuff and a leaner 100 shot.
10-19-2010, 03:30 PM
#57
not a bad gain either. is it a turd off the line?
who left the speed gov on your hoe? tell them to yank that **** off! your number will be lower on a 2nd gear pull I think. mine has always been 3rd gear and up to 6800rpm. next time to 7200.
who left the speed gov on your hoe? tell them to yank that **** off! your number will be lower on a 2nd gear pull I think. mine has always been 3rd gear and up to 6800rpm. next time to 7200.
10-20-2010, 05:32 AM
#58
TECH Addict
iTrader: (21)
Join Date: Apr 2008
Location: Fort Worth, Texas
Posts: 2,625
Likes: 0
Received 0 Likes
on
0 Posts
Blackbear did when he tuned it from stock. Im not sure if I should raise it. I have the wonderful 1 piece steel driveshaft that seems to let go at high speeds. I think with the 3.42s in 3rd at 6200rpm thatd put me over 150mph on the rollers..? Also the trans wont hold third unless its above 80, so its a shitty deal overall... Damnnn your gonna push it to 7200? Whew...
Thread
Thread Starter
Forum
Replies
Last Post
lucas287
Tuning, Diagnostics, Electronics, and Wiring
31
01-12-2021 06:18 AM
gaps
GMT 800 & Older GM General Discussion
10
10-15-2015 02:53 PM
Alvin@PCMofNC
Sponsor's Announcements, Sales, and Specials
0
09-03-2015 06:38 AM
