The 418 is going to turn into a 423 so I need my cylinders bored.

 

I had work done at Joey's Engines on Ella and 34th, they did great work.

 

damn Cody, what the hell? You put like 20 miles on that new engine and you already want more??????

 

It has 4K on it and Im ust going to go ahead and order 4.040 pistons incase a cylinder is scored when I break it down. Not a case of wantign more. 5 CI wont be noticeable performance wise just need nice clean cylinders. Going for roun two but Ill have another 100hp on motor. 550rwhp N/A here I come

 

I was thinkin USA racing engines but dont know of anyone with personal experience. Im building this motor myself and sober this time I think lack of sleep and being under the influence of alcohol contributed to my problems.

 

So much so that you were gonna use a grinder on your piston skirts. haha. I understand how you got burned out now. My tranny is sitting on the ground right now and im about to light my phuckin truck on fire.(gas can next to the garage door is starting to look awfully friendly. ) SHOULD be up and running by tomarrow though.

 

Yes you can get burnt easily thus my truck has sat for the last 6 months basically. I called you back cracker what did you need?

 

MTI maybe?

 

What about the guys that Nelson used to do tuning for?

 

I wouldnt let MTI touch my **** with a 100 foot pole. Meatwad the people you are talking about is Nickens racing and they are expensive and Im sure I can get just as good a job done somewhere else for less. Boring and honing a block isnt hard or require a whole lot of skill.