A 6.0L bare block that is .060 over with the 8 matching forged pistons that came from it.. They say CP on them. I have no other info except I believe they are -11cc dish. Not all shown as they need to be pulled from the rods. Will come with matching pins and clips.

$650 Local pick up near Anaheim CA.

 

That bore makes it a 427? correct?

 

This particular setup was used with a stock crank with a 6.125 Forged Rod.

If you use a 4.125 stroke crank with a 4.060 bore you can achieve 427 Ci

With a 4in Stroke it's a 414

 

Someone asked If I would separate the pistons. Yes, I will Separate.

 

Here is the pistons. Rings were only removed from 1 piston.

 

How long was that engine run?? The bottoms of the istons are clean as hell, tops look like they took an oil bath....

 

About 1000 miles and 15Lbs of boost. Also had some E85 thrown at it too.

 

That explains that....lol

 

Block Sold!!!

Still have pistons.

 

What size pistons and what you want fo them