as far as inspection goes do i need em... im putting on my roll pan and i dont have like any little holes or mounts or anything like the bumpers do for the license plate lights, dont wanna rip my ******* roll pan off everytime i gotta get inspected and put the bumper back

 

plate has to be lit up man its the law.... inspection might not get you.. but if a cop is following you at night your getting nailed man

 

im sure you could purchase some LED's bright white and wire them to the truck connector, might have to drill small hole in pan.

Im running without lights on my plate and havent had any probs with cops, I figure if they are driving behind me at night there headlights will light up my plate so unless they decide to turn off their headlights to make sure i have a tag light they shouldnt be able to tell.

 

yea ill just have to do that then, i just cant think of ANY way on how to get them stock lights on my pan w/o it lookin retarded. i drove around wit my pan on my blue truck like that for about a year and just figured that 2, if a cops behind me hell have his lights on my plate

 

Some people use the plate frames that have lights built into them. I think stylin carries them.

 

ill check it out thanks

 

I have also seen some lights that go in place of the plate bolts, little LED's i think... Can't remember where though... maybe summit?

 

I've been pulled over for no license plate lights. I was on my way to Mexico and the cop real close to the border said that when cars got stolen and were headed out of the country that they would often unplug the lights. He was radaring people on the side of the road though, couldn't see my plate when I drove by.

 

that's probably the cleanest and best bet. check out the mini-trucker sites, they run into this all the time

 

yea i def dont wanna get busted but at the same time i dont want these big stupid ******* lights hanging off my roll pan so hopefully ill be able to find some kinda like little light strip or somethign