Some sprucing up of the RCSB
#51
Thread Starter
TOTM: June 2007
iTrader: (2)
Joined: Nov 2006
Posts: 1,781
Likes: 7
From: Hamilton, Ontario
Ya I probably put 1500km on it this summer. Works great. Took it off the road late august cause I smoked the trans outta my tvs crew cab and stole the fly level 7 outta this truck
Ordered a tick stage 3 t56 and all the goodies to swap to a 6 speed
Ordered a tick stage 3 t56 and all the goodies to swap to a 6 speed
#56
Surgically clean as always, Brandon.
Have any photos of engine bay currently? Did you still route harness to side, or go back to over the top since you went back to the TBSS intake?
That's gonna be some sloppy good fun with the t56 in there. I'd definitely be going the same route if I weren't 4wd.
Are you going to regear the rear for the trans?
...I thought you had bigass wilwoods on there, no?? Or maybe just front?
Have any photos of engine bay currently? Did you still route harness to side, or go back to over the top since you went back to the TBSS intake?
That's gonna be some sloppy good fun with the t56 in there. I'd definitely be going the same route if I weren't 4wd.
Are you going to regear the rear for the trans?
...I thought you had bigass wilwoods on there, no?? Or maybe just front?
#57
Thread Starter
TOTM: June 2007
iTrader: (2)
Joined: Nov 2006
Posts: 1,781
Likes: 7
From: Hamilton, Ontario
sorry havnet responded
To pics of engine bay, Harness runs beside the intake not over it, looks better that way. Im been back and forth on what intake to run. I have a 08+ intake ready to go on, but Im doubtful on the gains. Plus They are ugly as sin. Im gonna keep my stock truck intake and Vortec MAx engine covers.
Truck ended up getting a t56 magnum and monster stage 2 twin disc billet clutch
Big wilwoods wont fit on the rear, soon as the axle is cut it brings it so close to the leafs. I had to rotate the axle just to get the 2 piston suburban brakes to fit
To pics of engine bay, Harness runs beside the intake not over it, looks better that way. Im been back and forth on what intake to run. I have a 08+ intake ready to go on, but Im doubtful on the gains. Plus They are ugly as sin. Im gonna keep my stock truck intake and Vortec MAx engine covers.
Truck ended up getting a t56 magnum and monster stage 2 twin disc billet clutch
Big wilwoods wont fit on the rear, soon as the axle is cut it brings it so close to the leafs. I had to rotate the axle just to get the 2 piston suburban brakes to fit
Thread
Thread Starter
Forum
Replies
Last Post
xtrooper89
Tuning, Diagnostics, Electronics, and Wiring
0
Sep 21, 2015 06:03 AM




