I used to own 4 jcb's 2 micro diggers 1 1.5 tonne and a 3cx and one skip tip dumper. I have been on a few factory visit's quite impressive seeing the big press brakes bending the thick steel plates. Perhaps I should've asked if I could have gone on a JCB USA factory tour.



Thanks again for the welcome guys.

 

When I asked about your mods I wasn't prepared for this!! Awesome setup. You'll have to keep us posted. Very interesting build.

 

welcome bro

 

all we build here is backhoes loadalls and skid steers.

 

Welcome to PT.net sweet looking truck.

 

welcome ivan, good to have other members from other countries

 

Heck I never would of thought you Britts had a hot rod scene!

 

It didn't take you too long to find where the SSS guys hang out after hours I am sure you will find even more good stuff to do to your truck now!

 

You would be supprised, check out the forum with no decorum,www. rebel-v8.com alot of strong language on the site but a great bunch of guys. that's how we got into racing , there's a few members from your side of the pond as well.







Your right done a bit of searching and already found two more mods I want to do, I want to do the brake hydro-boost thing and also want to go with a two piece drive/ prop shaft, I've not managed to find a pic of the prop setup yet (cos' a pic says a thousand words) I'd like to see how the cross member and center bearing are set up.

 

Here is more on the build. Did you get the header problem worked out? There are alot of nice/fast trucks over on that side of the pond.

http://www.fulciotestserver.com/VBul...ead.php?t=2353