Good vid man, you've had some hard luck there!

 

A friend of 1funZ71, he said it runs 15.8, here is a LINK

There where a few things that helped out with the detonation that caused the pistons to brake. Number one was I did not let out of the throttle even though I could see the KR on the scanner. Number two is the fact my MAF was not working right. It would not read above 25 lb/min, Allen Nelson was doing the tuning and he had a very hard time getting it to run right, by the time Allen figured out the problem I just installed the 6.0, the bad MAF did not set no codes, and I never knew what to look for in my scans at the time. I talking to Allen on the phone a few times while we (he) trouble shot the thing. He figured out the maf wasn’t reading right, luckily my wife just bought a 05 Silverado; it was nice to be able to try a new maf before I bought one. This is another reason I stand behind Allen, I'm sure I would have never figured out my problem until it started setting codes. And he shipped me a lot of ECM's before I got HPTuner and was able to send him what he needed to fix the thing.

Thanks for the complements everyone I'll start working on another vid soon.

 

Very cool man! I like how you were not afraid to show breakage.

 

very cool vid indeed...lots of work went into this one for shure...

 

so what the hell dose this thing run in the 1/4

 

That is what I would like to know. lol All this work and I still don't know if I've got a fast truck lol. Hopfully next spring me and 1funZ71 will be taking a road trip to sac.
It did run a G-tech time of 13.88 @ 101 at 6PSI

 

Still hoping to get this vid emailed to me so I can see it.

 

nice vid and bad *** truck

 

Wilde, what video software are you using?

 

Windows movie maker, it is a older version (I think). It works well, but then again I've never used anything else, so if any one knows of a better program be sure to let me know.

Thanks again everyone.