Velleman O-scope
#1
I have Velleman HPS10SE oscilloscope that I used for my subwoofer install. It is in brand new condition because it has only been used for 1 project. This is the special edition version with the blue LCD that I think is easier to read and you can use it at night. It also has a carrying case which is nice for keeping it in good condition.
Features
* 10MHz sampling rate
* 0.1mV sensitivity
* up to 2MHz analogue bandwidth
* 5mV to 20V/div in 12 steps
* 200ns to 1hour/div time base in 32 steps
* full auto set up
* trigger mode: run, normal, once, roll, slope +/-
* DVM readout with x10 option
* audio power calculation (rms and peak)
* dBm, dBV, DC, rms ... measurements
* signal markers for Volt and Time
* frequency readout (through markers)
* recorder function (roll mode)
* signal storage (2 memories)
* LCD: 128x64 pixels / high-contrast
* up to 20h on alkaline batteries
- maximum size battery is 2000mA (bigger batteries will not fit)
Here's some pics of the actual O-scope and 1 action shot



$110 shipped OBO
-John
Features
* 10MHz sampling rate
* 0.1mV sensitivity
* up to 2MHz analogue bandwidth
* 5mV to 20V/div in 12 steps
* 200ns to 1hour/div time base in 32 steps
* full auto set up
* trigger mode: run, normal, once, roll, slope +/-
* DVM readout with x10 option
* audio power calculation (rms and peak)
* dBm, dBV, DC, rms ... measurements
* signal markers for Volt and Time
* frequency readout (through markers)
* recorder function (roll mode)
* signal storage (2 memories)
* LCD: 128x64 pixels / high-contrast
* up to 20h on alkaline batteries
- maximum size battery is 2000mA (bigger batteries will not fit)
Here's some pics of the actual O-scope and 1 action shot



$110 shipped OBO
-John
Thread
Thread Starter
Forum
Replies
Last Post
JesseByrd
Tuning, Diagnostics, Electronics, and Wiring
8
Jun 5, 2012 05:39 PM



