who's had it done?
Jun 22, 2011 | 09:53 AM
#22
Teching In
Joined: Feb 2011
Posts: 25
Likes: 0
From: College Station, Tx
I know i would have picked up more hp but nothing sounds better than a cammed LS motor. I have done 3 cam jobs myself on some of my project vehicles, but for my 40 thousand dollar daily driver I don't trust myself enough haha
Jun 22, 2011 | 10:51 AM
#23
TECH Resident
Joined: Jul 2005
Posts: 847
Likes: 0
From: Bakersfield, CA
But with ARD you are rolling the dice way more so than if you did it yourself.
Jun 22, 2011 | 08:43 PM
#25
Thread Starter
TECH Enthusiast
Joined: Sep 2008
Posts: 539
Likes: 0
From: Pearland
Ya i can take a video for you tomorrow and get it up but it cost me like 4100 for parts and everything. I put down 397rwhp 385 tq and i am 4 wheel drive. I would have broken 400 if it wasn't 102 degrees today in their shop! I haven't had any bad run ins with them so far and they have worked on a few of my cars. But looking at some of those threads above it does make me think twice...
Jun 23, 2011 | 12:25 AM
#26
Teching In
Joined: Feb 2011
Posts: 25
Likes: 0
From: College Station, Tx
I tried taking a video but it didn't turn out good in the dark, but i will try to get one tomorrow during the day. As far as 1/4 mile i was curious too and i ran my G Tech. With one pass on the G Tech it said 13.4 at 102.5, so im sure I could get that down to low 13s when i have a few runs behind it.
Jun 23, 2011 | 10:19 PM
#27
Thread Starter
TECH Enthusiast
Joined: Sep 2008
Posts: 539
Likes: 0
From: Pearland
I tried taking a video but it didn't turn out good in the dark, but i will try to get one tomorrow during the day. As far as 1/4 mile i was curious too and i ran my G Tech. With one pass on the G Tech it said 13.4 at 102.5, so im sure I could get that down to low 13s when i have a few runs behind it.
