Tie Rods..............
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Tie Rods..............
Hey guys- got alignment yesterday guy said I need tie is going south, I told'em OK- I'll look at it thanks for heads up. After a look I concluded gonna replace the inner and outer both sides, question is- where do y'all get good parts?
TIA
TIA
#2
TECH Senior Member
iTrader: (2)
I pretty much go with NAPA 95% of the time. Don't by the cheaper PCC brand and get the NCP (napa chassis parts). Far better quality and basically all the NCP parts have lifetime warranty on them.
Look for coupons online to save you some cash and atleast here in MN if you order online to save in-store you get 10% off your order.
Look for coupons online to save you some cash and atleast here in MN if you order online to save in-store you get 10% off your order.
The following users liked this post:
Mark Johnson (05-24-2017)
#7
TECH Fanatic
Thread Starter
iTrader: (1)
Thanks for all the input guys- I've seen Moog Problem solver pieces in some videos, but really- are they that much better? About the only thing I plan to do ultimately are some spindles up front(wondering about additional track width with that) and hangar shackles out back and nothing big on tires....
Trending Topics
#10
TECH Fanatic
Thread Starter
iTrader: (1)
Hey guys- getting around to dropping the hammer on the tie rods, now wondering about rebuilding the entire front tend. Big question here, what is it that really wears out in the front end? No reservations on rebuilding the front end with 140k on the clock, just wondering what and how it wears out.........