riddick1224

iTrader: (1)

I would get a hold of Charlie Wheatley. -------------> He is a sponsor.

tarinitup

iTrader: (11)

In that case I would pm 00z71. He is local, has a wideband, hptuners and is very fairly priced.

03GMC

iTrader: (2)

Wonder if he can put the cam in for me too? Seems like everyone I know is busy.

silver-mod-o

iTrader: (15)

if you have any mechanical knowledge and confidence in your skills, do it yourself... its VERY simple. I did my ext cab in 7 hours from pulling it in the shop to startup with the new cam... Its not a bad job... and I took SEVRAL breaks and took my time on this one.

03GMC

iTrader: (2)

I might is there any really good write ups on doing it on a truck? I work at a dealership and have access to tools. I would need a good write up though.

silver-mod-o

iTrader: (15)

http://www.ls1howto.com/index.php?article=23

This one is for an F body but the steps are the same minus some of the tear-down... you dont have to take nearly as much **** off a truck to do it as you do a car.

and/or, search around on here... a few people have done write-ups if I recall..

vandy1821

I used that write up for my cam swap it was perfect and easy to do.

03GMC

iTrader: (2)

What does a cam install with springs and pushrods cost usually?

LMSeven

iTrader: (3)

I've been running my 212 218 for a while now untuned, drives fine. On an old W4M tune too. Can't wait to get to the dyno and get a real tune...

LMSeven

iTrader: (3)

Probably close to the cost of your cam, springs, and push rods.