WTD Hydroboost Parts
#1
Thread Starter
Where's the Beef?
iTrader: (8)
Joined: Jan 2007
Posts: 9,382
Likes: 1
From: Dover, Oklahoma
I need the Brake pedal and the 3 hoses that go to and from hydroboost (2 pressure lins and 1 low pressure line)
If you have any or found a cheap place to get it let me know. I'll try to monitor ebay but if you see something please post.
Also what size cap goes on the back of the intake?
If you have any or found a cheap place to get it let me know. I'll try to monitor ebay but if you see something please post.
Also what size cap goes on the back of the intake?
Last edited by viciousknid; Aug 12, 2009 at 09:18 PM.
#2
I got a good price for new AC Delco pressure hoses and the pedal from OEHQ.com
Haven't found the low pressure line anywhere other than the dealer for a stupid price. It's just a rubber hose with the bends molded in so I plan on using a regular rubber hose rated to handle trans or ps fluid and being careful to route it so it isn't kinked. Unless I stumble upon a good price for the correct hose.
Haven't found the low pressure line anywhere other than the dealer for a stupid price. It's just a rubber hose with the bends molded in so I plan on using a regular rubber hose rated to handle trans or ps fluid and being careful to route it so it isn't kinked. Unless I stumble upon a good price for the correct hose.
#4
Yep. Guess there isn't enough demand for that particular hose for the aftermarkets to make it. I did find the after market pressure hoses for a **** hair cheaper on Amazon, but I went ahead and order the AC Delcos. Here are the part numbers I used.
1 F-pedal .....................................ACD 15734409 $32.76 $32.76
1 Power Steering Grommet Inlet Hose ACD 36-353800 $23.08 $23.08
1 Power Steering Grommet Inlet Hose ACD 36-365463 $18.06 $18.06
1 F-pedal .....................................ACD 15734409 $32.76 $32.76
1 Power Steering Grommet Inlet Hose ACD 36-353800 $23.08 $23.08
1 Power Steering Grommet Inlet Hose ACD 36-365463 $18.06 $18.06
#5
Joined: Jan 2006
Posts: 16,282
Likes: 438
From: Huntsville, AL
The low pressure hose is extremely low pressure. As in drip when the engine is running and a few tablespoons when you let off the brake. You could use heater hose if the temp and oil ratings are sufficient. Back intake cap is 3/8. I had to buy a big pack to get that one I needed. A 1/2" will suffice, but its technically 3/8".
Thread
Thread Starter
Forum
Replies
Last Post
SLOPONY
GMT 800 & Older GM General Discussion
20
Oct 18, 2016 06:05 AM
Fast86z
GM Engine & Exhaust Performance
4
Aug 23, 2015 12:35 AM
mrgrim
GMT 800 & Older GM General Discussion
0
Jul 8, 2015 08:12 AM







