obviously doesn't provide any tangible evidence but possibly could be useful...

 

I just need to know how big the hole in the middle needs to be and i can build those with the bar mounts on them.

 

ok so the clap part tubes extend out and the triangles fit over them.. but wont that make some noise or grinding when bars dont have full tension on them with metal on metal?

 

I doubt it, but you could put a little bit of grease on it if your worried about it. There is really very little movement there once adjusted.

 

well im gonna do some measuring with mine and a stock leaf truck to make sure there same or close. but im pretty sure i would like a pair, ill let you know..

 

Funds Paypaled as promised earlier in this thread

 

Any chance some could be made to fit an OBS?

 

kyle, i'll try and get a measurement this week sometime. i'm really interested in a set of these!

 

If i can find something to take some measurements on...

 

Looks like .69 inches. I also measured in mm and found it to be 17mm. As you can tell, the hole is larger than the dowel that's in it. I'm sure you're aware that the hole isn't perfectly in the middle between the ubolts either. It looks to be approximately 2.5" from the front of the plate on my flip kit...just let me know if you need anything else.

Can't wait to get a set of Kyle-Tracs!