PM responded.

 

Is this still available? I'm interested in the whole set. I've currently got a 2.75 pulley on the radix, an HD tensioner, and a fleet runner belt. Bolting up the 10% OD and the 2.6" Maggie pulley should help quite a bit. How much boost was your radix pushing when you had the kit installed? I've installed supersub's 1" radix spacer and was wondering how much you think that'd affect your bracket with the built in idler? When I installed the spacer, I had to route out the bolt grooves in the support bracket so it'd raise another inch and touch the bottom of the blower snout. So If I were to install your bracket and do the same, the idler would move up 1" as well. Do you think it'd still perform as designed? Would I run into any clearance issues? Is it safe to spin the mp112 that fast? And lastly, how did you go about pinning the 10% OD crank damper to the crank? Thanks a lot.

 

Sold.

But to answer your questions. A new bracket would have to be made to raise this up. The idler bracket would need the holes lowered 1 inch to work for you. The idler would be mounted in the same spot as it supoorts the front of the supercharger. I just drilled the balancer for the pinning of it. If you wanted to make this kit I could help you part it together.

 

That'd be great! I'm wanting to get the most out of my Maggie. Ill eventually go with a tvs2300 when I can afford it. Lol. I'm at about 7psi with the 2.75" pulley. Maybe a 2.6" with a 10% OD crank will put me at 10ish? I'd definitely like to piece together this kit. Any help you could give me would be awesome. Just send me a PM! :thumbs: