This is a complete 8 groove system for a Radix with a 10% OD SFI crank pulley, and 2.6 supercharger pulley. I made a support bracket to mount under the snout that contains an extra idler to improve belt wrap. It works very good. It includes 3 extra wide idlers, spacers, an 8 groove power steering pump pulley, an 8 groove oversized alternator pulley (oversized to keep it turning the same speed with the larger crank pulley), and a very low mile gates green belt it has right around 1200 miles on it. The prices for everything new without the bracket and spacers was just under $700. I will sell it for $500 shipped. Im not willing to seperate anything at this time, I would sort of like this to go as a kit as it was intended.

 

Pm sent

 

PM replied.

 

Holy crap that gap in the belt is tight!!

 

HA HA yep, right where I wanted it. It actually works real well. When the ehgine is turning it is throwing the belt away from the pulley. I had made one before, and it was throwing the belt towards the pulley, and I think it would occasionally rub.

 

Ttt..

 

What about the tensioner?

 

The tensioner went when I sold the supercharger.

 

Ttt.

Debating on parting this out.

 

PM sent