Got a brand new Labonte racing meth fail safe device! Pretty easy to plumb into your existing meth injection lines, and overall easy to install. Very nice piece to have if you're always worrying about your meth system malfunctioning.
***also have a meth tank I'm going to include in the sale***
$100
<a href="http://s1341.photobucket.com/user/Jordanh1/media/Mobile%20Uploads/image_zpsyb1faps1.jpeg.html" target="_blank"><img src="http://i1341.photobucket.com/albums/o756/Jordanh1/Mobile%20Uploads/image_zpsyb1faps1.jpeg" border="0" alt=" photo image_zpsyb1faps1.jpeg"/></a>
<a href="http://s1341.photobucket.com/user/Jordanh1/media/Mobile%20Uploads/image_zpsstl9ecgf.jpeg.html" target="_blank"><img src="http://i1341.photobucket.com/albums/o756/Jordanh1/Mobile%20Uploads/image_zpsstl9ecgf.jpeg" border="0" alt=" photo image_zpsstl9ecgf.jpeg"/></a>
<a href="http://s1341.photobucket.com/user/Jordanh1/media/Mobile%20Uploads/image_zps1mp602bw.jpeg.html" target="_blank"><img src="http://i1341.photobucket.com/albums/o756/Jordanh1/Mobile%20Uploads/image_zps1mp602bw.jpeg" border="0" alt=" photo image_zps1mp602bw.jpeg"/></a>

 

Open to trade offers too.....

 

Ttt.....

 

Bump.....

 

Bad question i guess, but hows it work...what wiring is required and what tuner etc does it work with...iv had issues w meth before and its not fun!

 

I believe there are a few ways you can wire it in. If your running a electronic boost controller you can wire it to the electronic silenoid, or you can wire it in your meth system somehow, but the easiest way is to just run your meth lines through the fail safe unit and when it runs low, or the pump goes out, or fluid flow drops below your flow rate trip point, the fail safe would automatically go to spring pressure on the wastegate. Not sure how all that would work on a SC setup? But I'm sure there's a way to wire into something.... I'm gonna read over the directions again