No problem, yes these are bolt in.

 

Do you know what part number it is? How long is the case? What did it come off of?

 

The case is 14" long and is 4" thick. Dont know the part number. I bought it new for my truck, an 04 silverado. It was too quiet for me so I replaced it with an IMCO. I have had about ten different setups on this truck at least. It stayed on for about a month. It has a good tone at idle and when you get on it, but while driving it was way too quiet for me. I now have the longtube headers and no cats with an slp loudmouth which is too loud. I was gonna put this muffler back on, but I ended up buying a larger magnaflow to quiet the headers down a bit.

 

update:cam sold.

 

Would you take 35 shipped for it?

 

Sorry, but no. It will costs about $20 just to ship it.

 

Whats the least you'll sell it for?

 

$45 shipped. If you want it, pm me.

 

How much pipe is left on the ends of the muffler? Is there enough to replace the stock muffler? How did you have it run? Did you use it with the stock pipes?

 

This was the very first muffler I put on my truck. It was a single in and single out muffler on the stock piping exiting in the stock location. Inlet side has about four inches plus the muffler inlet, so six inches. The exit side has about 8-10 inches plus the muffler outlet, so 10-12". It also has the factory hanger still welded on it. You could just place it up there to see where the hanger goes and where your cuts need to be.