07-13 SE Headers with stuff.
#1
For Sale: 07-13 Speed Engineering Headers with stuff.
I have a set of 1 3/4 Speed Engineering headers for sale.
They were installed and ran for a very short time, like not even 15 miles on them. They come with 3 good band clamps for the slip fits but you will need to buy just 2 more to make everything a band clamp. Included are several of a clamps that come with the headers originally.
Has all the pieces to make it work on either 4 speed or 6 speed truck.
Also will come with 8 spark plug boot protectors for the wires.
Price: $310 shipped.
They were installed and ran for a very short time, like not even 15 miles on them. They come with 3 good band clamps for the slip fits but you will need to buy just 2 more to make everything a band clamp. Included are several of a clamps that come with the headers originally.
Has all the pieces to make it work on either 4 speed or 6 speed truck.
Also will come with 8 spark plug boot protectors for the wires.
Price: $310 shipped.
Last edited by FFDP; 10-02-2017 at 01:13 PM.
#5
are these stainless steel?
will these fit AWD or 4x4?
any fitment issues?
is the center bung for wide band?
why only use for 15mintues
bump
will these fit AWD or 4x4?
any fitment issues?
is the center bung for wide band?
why only use for 15mintues
bump
Last edited by thebrain; 09-26-2017 at 07:45 AM.
#7
These were on a 4X4 truck, a AWD truck would be the same. I do not know how fitment is on tahoe/suburban/yukon or if they work on any other SUV.
Fitment was fine, cleared the frame plenty on the headers and the y-pipe cleared the cross over good. Getting the pipes fully seated in the slip fits is key. I'd suggest another band clamps for the rear slip pieces or just have them welded to prevent leaks. The front 3 band clamps seal great.
Center bung is for a wideband.
Plans changed and went a different route, not much else to it. They are basically brand new headers with minimal run time.