Smoothing a TBSS intake, vs structural integ??
May 4, 2011 | 08:31 PM
#22
Thread Starter
Joined: Apr 2004
Posts: 16,820
Likes: 2
From: In a van DOWN BY THE RIVER
You dick 
(jkn)lucky you.. None the less that looks good. I would def smooth it out if I were you. Did the harness use to run over top of that one like the nbs trucks, or was it always tucked towards the back some??
May 4, 2011 | 09:33 PM
#25
Thread Starter
Joined: Apr 2004
Posts: 16,820
Likes: 2
From: In a van DOWN BY THE RIVER
On a side note. I might just make a cover for it, that hugs it tight, covers the sensors, all up.. I am thinking stainless, polish it or brush it... Hmm me wheels are turning.....
May 5, 2011 | 12:09 PM
#26
Cleaning up that harness looks good. Smoothing it out would definitely make it look better. I would definitely do it over making a cover. Tidying up the wiring makes a huge difference in appearance. Smooth it out and color match it 
May 5, 2011 | 12:26 PM
#27
Thread Starter
Joined: Apr 2004
Posts: 16,820
Likes: 2
From: In a van DOWN BY THE RIVER
Well there is some downfalls to smoothing it out.. There would be a few things still there, the MAP sensor, 2 vacuum ports.. I think I am leaning towards the cover. I assure you it will be done tastefully.. But I am still not 100% on how I am doing it yet..
May 5, 2011 | 10:40 PM
#28
the wiring harness part is the easy part. I talked to my head porter and he said he would port mine for $150, I am thinking about buying another one for him to port before the LS1 goes in.
May 10, 2011 | 01:23 PM
#30
TECH Fanatic
Joined: Oct 2005
Posts: 1,379
Likes: 0
From: Woodstock Ontario Canada
