Heavy duty motor mounts for 2018 Seirra?
Apr 26, 2023 | 12:45 PM
#11
Joined: Jan 2006
Posts: 16,282
Likes: 438
From: Huntsville, AL
When I started it for the first time with the mounts, I could feel slightly more vibration. That was essentially a back to back comparison (within a day), but I get in and start it now, and honestly could not say that I feel any vibration. I likely got quickly accustomed to any small increase of vibration transfer. MORE than worth it to not fail mounts, especially now that it has headers. The internet is full of reports of these stock mounts failing, on stock power levels too. Stock cam in my case.
Apr 26, 2023 | 02:08 PM
#12
Thread Starter
Launching!
Joined: Mar 2019
Posts: 267
Likes: 208
From: So Cal
It will probably be a minute, the AC juice on the new trucks is expensive and with the new houne near completion I need to hold on to all my pennies at the moment. But these will ne the path I go.
Apr 26, 2023 | 02:13 PM
#13
Thread Starter
Launching!
Joined: Mar 2019
Posts: 267
Likes: 208
From: So Cal
When I started it for the first time with the mounts, I could feel slightly more vibration. That was essentially a back to back comparison (within a day), but I get in and start it now, and honestly could not say that I feel any vibration. I likely got quickly accustomed to any small increase of vibration transfer. MORE than worth it to not fail mounts, especially now that it has headers. The internet is full of reports of these stock mounts failing, on stock power levels too. Stock cam in my case.
So many questions but ill just have to wait and see.
Apr 28, 2023 | 04:34 PM
#14
same here. When I installed my stroker it felt extra shaky but after a month I got used to it then I thought something was wrong🤣I will say when I tuned for 85 it felt like it smoothed out more🤷🏼♂️
Apr 28, 2023 | 05:35 PM
#15
Staging Lane
Joined: Jul 2018
Posts: 56
Likes: 6
Thats good feedback. Most guys tell me they cant tell any difference vibration wise especially on the 99-06 and 14-18 trucks. The 07-13 trucks are sometimes pickier but adjusting idle speed and making sure the engine doesnt have a slight miss at idle usually takes care of those too.
Jun 12, 2023 | 12:16 PM
#16
Thread Starter
Launching!
Joined: Mar 2019
Posts: 267
Likes: 208
From: So Cal
Jun 12, 2023 | 02:32 PM
#20
Joined: Jan 2006
Posts: 16,282
Likes: 438
From: Huntsville, AL
Got plenty of material on hand just not enough hours in the day to weld everything I need, but go ahead and order some and ill get you in line lol. Since ive hired basically a full time guy things are going better, but every time I increase my output I get busier so I always stay behind. Been working hard on a few things I am excited about but just dont have the time to produce them on top of my regular stuff.
