I am looking to do cam and converter in my 2002 gmc sierra scsb 5.3.I am looking at the stage 4 btr truck cam and Circle d 3000-3200 stall my question is there another set up that may make more power?Is this setup good?Only mods as of now is long tubes and cold air intake. THANK YOU FOR YOUR INPUT

 

Do you want more power or do you want to be able to drive it? lol If this is a daily driver, that is plenty before you put a set of ported or 243 heads on it. What gear do you have?

 

I would run the 220r from Texas Speed! 220 intake 220 exhaust 600 lift on both and you can run that on a 110 - 114 LSA.

Several people on this forum can vouch for me when I say that the 220r cam with a 3000-3200 stall is a sweet set up for a 5.3 truck. I ran that combo for a really long time and it was the most fun my truck has ever been. Power all over the board and had a nice clean sounding idle for a truck. The 224 intake is getting a bit big for a 5.3 IMO. Many will say otherwise, but I would not run anything that big on a 5.3.

Avery

 

drspencer just trying to get best performing setup for cam and conv. truck has 342 gears in it

 

slow05cc thanks for your info I will give you a call tomorrow I have a couple questions thank you

 

Definitely agree with slow05cc considering the rear gear. Want some stall and that 224 may be a little much...

 

Yessir! Call anytime!