anyone running Bryan Tooley valve springs?
 

I'm about to grab some new springs, was going to get the PRC duals with the tool steel retainers then I saw the Bryan Tooley duals .660" max lift with tool steel retainers and they're $40 cheaper. Was just wondering if anyone has run them on here and had success?

I have been running them for awhile. No issues at all.

I ran them and they where great have prc now and they aren't as pretty but should work haven't run them yet

I have a set he recommended for my set up. they are everything he said they would be.will buy from him again

I'm running the Platinum duals with titanium retainers. Very good springs.

I'm not going to get the set with the titanium retainers, I talked to them today and they told me the weight difference was less than 1 gram for the retainer. That's nothing to us.

I was looking at his pushrods for the 5.3 and his prices are not that bad.

The shop I had my cam done at uses all BTR stuff unless you supply something different. Next time around Ill be using their springs, retainers, push rods and lifters.

The stuff is amazing especially for the prices.

I have used them, worked great. Brian is also very nice to deal with.