bend the boots a little, untiil they dont touch the headers

 

I'm using MSD's with my StainlessWorks LT's, but I'm sure the stockers would be fine for my application also. As mentioned above, I just had to turn the boot on the coil to keep the wires from touching the primary tubes.

 

Well thank you everyone for your input. There is no way for me to bend the boot so they don't touch. Maybe I'll take a picture for you guys. But again thank you for all the good input.

 

Stockers

John

 

stock with my pacesetters and no problems so far but I am switching to 8.5 mm MSD's

 

MSD's here too. All I did was bend mine also. You can also buy plug insulators.
Here's a link.http://store.summitracing.com/egnsea...115+4294814104

 

stock with pacesetters

 

Tywrap a stiff copper wire to your plug wires, then you can bend them into any shape you want.

 

FWIW, the replacements from AutoZone work perfect vs. stock wires. You have to buy a complete set though

 

Pics would be good if you say you can't bend them?
Maybe have someone stronger try it? jfwy


Stock here too btw.