Hi, I am doing an engine swap into my 96 Chevy Impala using a 6.0l from a 2007 Gmc Sierra HD. I've looked all over the place for engine wiring schematics. Does anyone have wiring schematics or pictures of the different connectors? Any info would be appreciated.

 

what are you looking for ? the pcm connector end views from the 07??? I can get either let me know...

 

I know the pcm connectors but I don't know these:


I also don't know the drive by wire pedal connector. If you have any wiring schematics I would appreciate those also.

 

you need to tell me what connectors you need. female or male side, I can get you whatever. The 2nd pic looks like a trans connector, but i am not sure.

 

The bottom one looks like the connector to the throttle control module

 

I would still like to know what is the connector for in the top picture?

 

I think it may be an ABS connector. Can anyone with an 07/08 truck verify this?

 

the top pic is just a bulkhead connector. Lots of things go throught there

 

That's what I am trying to figure out what exactly goes through there. This connector is on the same main harness as the PCM connectors. I know it's not a TCM connector because the 6l90 tranny has it internally.