I'm looking into a 3200 stall, and considering Fuddle. My question is have any of you guys experienced any problems with them? Or any reasons I should go with someone else, or is this a good converter? BTW it will be going in when I install a TR220

 

I am on my third Fuddle converter. My first was a 3600 9.5" HP Truck converter and it was really loose with my h/c 5.3 and LS1 setups but hit the tires much harder than my previous TT3000. A few months after installing my built 65 I had a shattered pump and broken hub on the converter. Don't know which happend first but both my tranny builder and Fuddle took car of the situation and I got a new converter built and sent to me at no charge. I had this one stalled down a bit to 3400 and was a bit tighter. I just traded in that converter on one of the new HD Truck 10.5" converters with a 2400 stall for the new setup. I love this converter so far but I dont have the KB installed yet. It is super tight while driving but does indeed flash 2400ish. Although customer service may be a little slow, they will ultimately take care of you and I have been very happy with their products.

 

theyve taken care of me so far. rebuilt it for me once even though i didnt buy it from them. the guy i bought it from sent it to them to be freshened up, then sent it to me. then i blew a tranny and they rebuilt it AGAIN for free putting the stall up around 3600.

 

i've had mine for about 3 months and i'm loving it. i bought it off of 1slowhoe who had it restalled at 3200 and i've had no problems up to now. plus john gave me great customer service.