Hellwig sway bar and TA girdle cover Fitment
Aug 24, 2014 | 08:14 PM
#1
Hellwig sway bar and TA girdle cover Fitment
I know there is a lot of question about the rear sway bar fitment when you have a aftermarket diff cover.
Here is one that works
Hellwig sway bar part# 7634
Cleared the 3'' exhast
This clamp goes to the left of the shock mount
The mouting/adjusting straps were too long so I trimmed two of the bolt holes off.
Here is one that works
Hellwig sway bar part# 7634
Cleared the 3'' exhast
This clamp goes to the left of the shock mount
The mouting/adjusting straps were too long so I trimmed two of the bolt holes off.
Thread
Thread Starter
Forum
Replies
Last Post
