Well back in the summer I redone the setup that can be seen in the kbracing intercooler behind the grille thread. So I wasnt completly happy with it and decided to do it again. So here is the way it came out. I had to drill 3" holes through the headlight housings to run the piping through and make brackets to mount the intercooler. I still have to order some 90 degree elbows for the intercooler with 4" legs, the ones on there now are pieced together. All in all I think it came out great, bring on the comments.

 

Looks really good! I like your set up!

 

is that 2.5" piping for the intercooler?

 

3" piping all the way around.

 

Did you notice any changes in iats or performance moving the ic by the radiator?

 

Looks great. I've been wanting to move mine too. Where did you put the trans cooler?

 

Well I have no way to check iats but the truck does seem to accelerate quicker. Boost seems to come in quicker. One thing that did change for sure is my a/f went from high 11s to low 11s.

 

My trans cooler is still in the same spot at the very bottom behind valance. I will get some more detailed pics when my new couplings get here and everything is 100% complete. I will say that I like this setup alot better than the previous. looks almost stock looking, like it was meant to be that way.

 

Looks great man. Nice work for sure!

Did you have to trim the back side of the grille?

Theres no too much room on these NBS trucks behind the grille, i know after trying to stuff a tru cool and and NNBS HEX behind my grille LOL.

 

No Tim I didnt have to trim the grille but it was a very tight fit, I will say that.